Sierra 1500 4WD V8-4.8L (2007)
1. Connect the right park brake cable eye (2) to the park brake actuator lever.
2. Install the park brake cable to the rear axle bracket by pulling the cable conduit (1) rearward and inserting the cable conduit into the rear axle
bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.
Notice: Refer to Fastener Notice.
3. Install the park brake cable clip bolt (2).
Tighten the bolt to 22 N.m (16 lb ft).
4. Connect the park brake cable (1) to the rear axle housing cover clip.
