Sierra 1500 4WD V8-4.8L (2007)
32. Untie the engine harness branches from the cowl panel and position over the engine.
33. Connect the engine harness electrical connector (2) to the ECT sensor.
34. Position the engine harness clip (1) to the generator bracket and install the bolt (3).
Tighten the bolt to 9 N.m (80 lb in).
35. Connect the engine harness electrical connectors (7) to the right side fuel injectors.
36. Install the engine harness clip (6) to the ignition coil bracket stud.
37. Install the engine harness clip (4) to the generator battery jumper cable.
38. Connect the engine harness electrical connector (3) to the throttle actuator.
39. Connect the engine harness electrical connector (1) to the ignition coil harness electrical connector.
40. Install the CPA retainer (2).