Sierra 1500 4WD V8-4.8L (2007)
6. Remove the steering shaft coupling nut (1) and bolt (2) at the upper intermediate steering shaft.
7. Remove the steering shaft coupling from the vehicle.
Installation Procedure
Important: If a new steering shaft coupling is being installed then transfer the position of the alignment marks from the old component to
the same locations on the new component. Failure to transfer the alignment marks may result in an off-center steering wheel after
installation.
1. Install the steering shaft coupling to the vehicle.
Notice: Refer to Fastener Notice.
2. Install the steering shaft coupling nut (1) and bolt (2) at the upper intermediate steering shaft.
Tighten the nut and bolt to 50 N.m (37 lb ft).
