Sierra 1500 4WD V8-4.8L VIN V (2004)
4. Remove the thrust washer.
5. Install the J 22536 as shown. Ensure that the J 22536 is firmly seated on the pinion.
6. Drive the pinion out using the J 22536 and a hammer. Strike the J 22536 slowly. Do not let the pinion fall out of the rear axle housing.
7. Remove the pinion preload shims from the drive pinion and set aside.
8. Remove the inner pinion bearing and the pinion position shim.
9. Important:
The ring gear bolts have right-hand threads.
Remove the ring gear bolts. Discard the bolts.
10. Notice: Refer to Ring Gear Removal Notice in Service Precautions.
