Sierra 1500 4WD V8-5.3L (2008)
1. Install the control rod onto the control lever first.
2. Slide the control rod forward.
3. Install the control rod onto the shift control lever.
Notice: Refer to Fastener Notice .
4. Tighten the control rod adjusting bolt.
Tighten the bolt to 15 N.m (11 lb ft).
5. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement) .
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement (See: Service and Repair/Removal and Replacement/BW
4485-NR3 - Transfer Case/Transfer Case Shield Replacement) .
