Sierra 1500 4WD V8-5.3L VIN B (2005)
1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).
3. Slide the module (2) to the left to engage the lower retainers.
4. Install the module retaining screws (3).
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the screws to 3 N.m (26 lb in).
5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure.
