Sierra 1500 4WD V8-5.3L VIN B (2005)
5. Remove the park brake cable from the park brake actuator lever.
6. Remove the wheel bearing.
7. Remove the park brake shoe.
8. Remove the park brake actuator lever housing from the backing plate.
9. Remove the backing plate.
Installation Procedure
1. Install the park brake actuator lever housing to the backing plate.
2. Install the park brake shoe.
3. Install the wheel bearing and adjust the park brake shoe.
4. Install the park brake cable to the park brake actuator lever.
5. Notice: Refer to Fastener Notice in Service Precautions.
Install the rear park brake bracket bolt.
Tighten the bolt to 61 Nm (45 ft. lbs.).
