Sierra 1500 4WD V8-5.3L VIN B (2005)
2. Install the park brake cable (2) to the lever (1).
3. Perform the following procedure to install the cable (2) to the backing plate (4):
1. Compress the spring (3) by pushing towards the lever (1).
2. Route the cable (2) through the slot in the backing plate.
3. Push the cable housing into the backing plate (4) until the locking tabs snap into place.
4. Install the cable to the mounting bracket until the locking tabs snap into place.
5. Notice: Refer to Fastener Notice in Service Precautions.
Bolt the cable to the differential clips.
Tighten the bolt to 22 Nm (16 ft. lbs.).
6. Important: After installing the cable to the rear axle holding clip, verify that clip is securely retaining the cable. If not, crimp the clip by hand
taking care not to pinch or kink the cable.
Install the cable to the differential clip.
7. For 25/35 series vehicles, connect the cable at the equalizer.
