Sierra 1500 4WD V8-5.3L VIN B (2005)
Notice: Refer to Fastener Notice in Service Precautions.
13. Install 2 NEW screws (1) to the casting.
^
Tighten the screws to 2 Nm (18 inch lbs.).
14. Install 2 NEW longer screws (2) to the motor cover.
^
Tighten the screws to 3 Nm (26 inch lbs.).
15. Install the encoder motor.
Transfer Case Shift Control Switch Replacement
Transfer Case Shift Control Switch Replacement
Removal Procedure
1. Remove the instrument panel (IP) cluster bezel.
2. Pull the tabs on the side of the transfer case driver control switch out.
3. Pull the transfer case driver control switch straight out from the panel.
Installation Procedure
1. Important: Make sure that the transfer case control switch is seated properly in the instrument panel before installing the instrument panel trim
bezel.
Install the transfer case driver control switch into the instrument panel.
2. Install the IP cluster bezel.
