Sierra 1500 4WD V8-5.3L VIN B HO (2006)
1. Connect the electrical connector.
2. Ensure the bottom of the molding is seated in the slots on the I/P.
3. Align the molding retainers to the slots.
4. Press the moldings straight in till fully seated.
Molding Replacement - Rear Window Lower
Molding Replacement - Rear Window Lower
Removal Procedure
1. Lightly pull the lower edge of the molding in order to release the clips. On extended cab fold the rear bench seat up. This will move the assembly
forward so that the molding can be accessed.
2. Lift the molding up and away from the glass in order to release the upper retainers.
Installation Procedure
1. Align the molding clips with the holes in the body panel along the back glass.
2. Snap the molding into place.
Trim Panel Replacement - Hinge Pillar
Trim Panel Replacement - Hinge Pillar
Removal Procedure
