Sierra 1500 4WD V8-5.3L VIN B HO (2006)
9. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness, if equipped with power lumbar.
10. Install the pressure sensor (2) to the front passenger seat frame, if equipped with the Inflatable Restraint Passenger Presence System.
11. Connect the electrical connectors.
12. Install the front nuts (2) onto the studs on the underside of the cushion.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the nuts to 21 N.m (15 lb ft).
13. Install the front seat trim panel.
14. Re-zero the Inflatable Restraint Passenger Presence System. Refer to Passenger Presence System Programming and Setup in Restraint Systems.
