Sierra 1500 4WD V8-5.3L VIN B HO (2006)
4. Remove the mode actuator mounting screws from the HVAC module.
5. Remove the mode actuator as an assembly with the actuator cam.
INSTALLATION PROCEDURE
1. Install the mode actuator as an assembly with the actuator cam.
-
Line up the heater/defroster lever with the mode actuator cam slot.
-
Line up the A/C lever with the mode actuator cam.
2. Install the mode actuator mounting screws to the HVAC module.
Tighten the screws to 1.6 N.m (14 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the electrical connection at the mode actuator (10).
4. Install the body control module.
5. Install the floor air outlet duct extension (1) to the floor air duct (2).
Air Temperature Actuator - Right
AIR TEMPERATURE ACTUATOR REPLACEMENT - RIGHT
REMOVAL PROCEDURE