Sierra 1500 4WD V8-5.3L VIN B HO (2006)
7. At the same time be sure to align the encoder phasing post (1) with the phasing slot (2) in the casting and insert the shaft into the bushing.
8. Verify that the output gear and idler gear are engaged properly.
9. Seat the harness wires on the casting channel.
10. Place the shim on the output shaft gear.
11. Press a NEW seal into the cover.
12. Install the cover.
Notice: Refer to Fastener Notice in Service Precautions.
13. Install 2 NEW screws (1) to the casting.
^
Tighten the screws to 2 Nm (18 inch lbs.).
14. Install 2 NEW longer screws (2) to the motor cover.
^
Tighten the screws to 3 Nm (26 inch lbs.).
15. Install the encoder motor.
