Sierra 1500 4WD V8-5.3L VIN B HO (2006)
3. Install the inner axle shaft into the inner axle shaft housing. Carefully tap the inner axle shaft into place with a soft-faced mallet.
4. Install the inner axle shaft and clutch fork assembly components into the inner shaft housing.
5. Install the inner axle shaft and housing assembly to the differential carrier case assembly.
6. If both the left side bearing and seal was removed, perform the following step. Install the left side bearing with the square shoulder in using the J
36609 (1) and the J 8092 (2).
7. If both the left side bearing and seal was removed, perform the following step. Install the new axle shaft seal using the J 45225 (1) and the J 8092
(2).
8. If both the left side bearing and seal was removed, perform the following step. Install the inner axle shaft into the differential case side gear using a
soft-faced mallet until the retaining ring on the inner axle shaft is fully seated within the groove in the differential case side gear. Pull back on the
inner axle shaft to ensure that the inner axle shaft is properly retained in the differential case side gear.
9. If both the left side bearing and seal was removed, perform the following step. Install the front differential carrier assembly.
