Sierra 1500 4WD V8-5.3L VIN T (2004)
1. Install the emblem (1) onto the grille (2) lining up the retaining clips with the openings.
2. Push rearward on the emblem until the retaining clips are fully seated.
3. Reinstall the upper grille baffle.
Emblem/Nameplate Replacement - Door (W/O SS)
Emblem/Nameplate Replacement - Door (W/O SS)
Tools Required
J 25070 Heat Gun
Removal Procedure
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Notice: Refer to Exterior Trim Emblem Removal Notice in Service Precautions.
4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.