Sierra 1500 4WD V8-5.3L VIN T (2004)
1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).
3. Slide the module (2) to the left to engage the lower retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the module retaining screws (3).
Tighten
Tighten the screws to 3 N.m (26 lb in).
5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure.
