Sierra 1500 4WD V8-5.3L VIN T (2004)
1. Install the cable to the vehicle.
2. Install the park brake cable (2) to the lever (1).
3. Perform the following procedure to install the cable (2) to the backing plate (4):
1. Compress the spring (3) by pushing towards the lever (1).
2. Route the cable (2) through the slot in the backing plate.
3. Push the cable housing into the backing plate (4) until the locking tabs snap into place.
4. Install the cable to the mounting bracket until the locking tabs snap into place.
5. Notice:
Refer to Fastener Notice in Service Precautions.
Bolt the cable to the differential (clips).
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
