Sierra 1500 4WD V8-5.3L VIN T (2004)
Power Steering Pump: Service and Repair
Power Steering Pulley
Power Steering Pulley Replacement
^
Tools Required
-
J 25034-C Power Steering Pump Pulley Remover
-
J 25033-C Power Steering Pump Pulley Installer
Removal Procedure
1. Remove the upper fan shroud.
2. Remove the drive belt.
3. Remove the power steering pump pulley using the J 25034-C.
Installation Procedure
1. Place the power steering pump pulley on the end of the power steering pump shaft.
2. Install the power steering pump pulley using J 25033-C.
3. Ensure that the power steering pump pulley (1) is flush against the power steering pump shaft (2), with an allowable variance of 0.25 mm (0.010
inch).
4. Install the drive belt.
5. Install the upper fan shroud.
