Sierra 1500 4WD V8-5.3L VIN T (2004)
4. Install the propeller shaft (5) to the front axle pinion yoke (1). Align the reference marks made during removal.
5. Install the yoke retainers (7) and the bolts (6).
^
Tighten the yoke retainer bolts to 25 Nm (18 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
7. Crimp the rear propeller shaft boot clamp using the J 43218 until the dimensions shown are obtained.
8. Install the transfer case shield, if equipped.
9. Lower the vehicle.
