Sierra 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
Rear Door Interior Handle: Service and Repair
REAR DOOR INSIDE HANDLE REPLACEMENT
Removal Procedure
1. Remove the trim panel. See: Rear Door Panel/Service and Repair
2. Remove the inside door handle mounting bolts.
3. Slide the inside door handle forward to release the unit from the door.
4. Disconnect the control rod from the inside door handle.
5. Remove the door handle assembly from the door.
Installation Procedure
1. Connect the control rod to the inside door handle.
2. Slide the handle into place.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners
requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use
paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint
clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid
damage to parts and systems.
