Sierra 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
8. Install the brake caliper bolts.
Tighten the bolts to 100 Nm (74 ft. lbs.).
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
14. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary.
