Sierra 1500 4WD V8-5.3L VIN Z Flex Fuel (2005)
7. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid.
8. Install the rear axle fill plug.
^
Tighten the rear axle fill plug to 33 Nm (24 ft. lbs.).
Notice: Refer to Service Precautions.
9. Lower the vehicle.
Lubricant Level Inspection - Rear Drive Axle (9.75 Inch Axle)
Lubricant Level Inspection - Rear Drive Axle (9.75 Inch Axle)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Ensure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.
5. Remove the rear axle fill plug.
6. Inspect the lubricant level.
The lubricant level should be between 0 - 4 mm (0 - 0.16 inch) below the fill plug opening.
7. If the level is low, add lubricant until the level is even with the bottom edge of the fill plug opening. Use the proper fluid.
8. Install the rear axle fill plug.
^
Tighten the rear axle fill plug to 21 Nm (15 ft. lbs.).
Notice: Refer to Service Precautions.
9. Lower the vehicle.
Lubricant Level Inspection - Rear Drive Axle (11.5 Inch Axle)
Lubricant Level Inspection - Rear Drive Axle (11.5 Inch Axle)
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Make sure the vehicle is level.
3. Inspect the rear axle for leaks. Repair as necessary.
4. Clean the area around the rear axle fill plug.
5. Remove the rear axle fill plug and the seal.
6. Inspect the lubricant level.
The lubricant level should be between 17 - 21 mm (0.6 - 0.8 inch) below the fill plug opening.
7. If the level is low, add lubricant until the level is between 17 - 21 mm (0.6 - 0.8 inch) below the fill plug opening. Use the proper fluid.
8. Install the rear axle fill plug and gasket.
^
Tighten the rear axle fill plug to 33 Nm (24 ft. lbs.).
