Sierra 1500 4WD V8-6.0L (2007)
Notice: Refer to Fastener Notice.
3. Install the valve lifter oil manifold bolts (2).
Tighten the bolts to 25 N.m (18 lb ft).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
5. Install the intake manifold.
Valve Lifter Replacement (L92 - First Design)
Valve Lifter Replacement (L92 - First Design)
Removal Procedure
1. Remove the cylinder head and gasket.
2. Remove the valve lifter guide bolts (211).
3. Remove the valve lifter guides (210) with the lifters. Note the installed position of the guides. The notched area of the guides is to align with the
locating tab on the engine block.
