Sierra 1500 4WD V8-6.0L (2007)
Notice: Refer to Fastener Notice.
2. Install the engine mount to engine bolts (1).
Tighten the bolts to 50 N.m (37 lb ft).
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block.
5. Install the left side exhaust manifold heatshield.
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
8. Install the left wheelhouse liner.
9. If the vehicle is equipped with 4WD, install the front drive axle. Refer to Differential Carrier Assembly Replacement (1500 FWD) Differential
