Sierra 1500 4WD V8-6.0L (2007)
Tighten the bolts/nuts to 100 N.m (74 lb ft).
10. If equipped, install the engine protection shield. Refer to Engine Shield Replacement.
11. Remove the jack or utility stand from the rear of the vehicle.
12. Lower the vehicle.
Important:
*
Ensure the oil cooler line being installed has a plastic cap on the end that connects to the quick connect fitting. If no plastic cap exists,
or the plastic cap is damaged, obtain a new cap. Install the cap onto the cooler line prior cooler line installation.
*
Do not use the plastic cap in order to install the cooler line into the fitting.
If equipped with RPO LY6 (6.0L) engine, install the oil cooler hoses to the clip.
Important:
