Sierra 1500 4WD V8-6.0L (2007)
Notice: Refer to Fastener Notice.
Important:
*
Ensure the flat of the valve, lines up with the flats of the snap in the enclosure.
*
TPM valves and TORX screws are one-time use only.
Assemble the tire pressure sensor (2) to the valve stem and install the new TORX screw (3).
Tighten the TORX screw to 1.3 N.m (11.5 lb in).
Important: Use and approved tire mounting lubricant. DO NOT use silicon or corrosive base compounds to lubricate the tire bead and
the wheel rim. A corrosive type compound can cause tire or rim deterioration.
1. Apply tire soap to the rubber portion of the valve stem (1).
2. Using a tire valve stem mounting tool, pull the valve stem through in a direction parallel to the valve hole on the rim.
