Sierra 1500 4WD V8-6.0L (2007)
Shift Cable: Service and Repair
4L60-E/4L65-E/4L70-E - Automatic Transmission
Range Selector Lever Cable Replacement
Range Selector Lever Cable Replacement
Removal Procedure
1. Position the steering column shift lever to the park position.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the clips on the cable from the floor panel reinforcement.
4. Ensure the transmission manual shaft is positioned in mechanical park.
5. Remove the retainer that secures the cable to the bracket.
6. Remove the cable clip on the transfer case, if equipped.
7. Remove the range selector cable end (2) from the transmission range selector lever ball stud (1).
8. Depress the tangs and remove the cable from the bracket.
9. Lower the vehicle.
10. Ensure that the steering column shift lever is still in the park position.
11. Remove the drivers seat.
12. Pull back the carpet and insulation around the driver's area.
13. Remove the instrument panel knee bolster.
