Sierra 1500 4WD V8-6.0L (2007)
2. Install the following components into the inner axle shaft housing:
1. Install the inner axle shaft (1) into the inner axle shaft housing (4).
2. Install the thrust washer (with tabs) (5).
Ensure the tabs on the thrust washer are aligned with the slots in the inner shaft housing.
3. Install the thrust washer (without tabs) (6).
4. Install the retaining ring (7) into the inner axle shaft (1).
3. Install the inner axle shaft housing into a vise. Clamp only on the mounting flange of the inner axle shaft housing.
Important: In order to obtain an accurate measurement, the inner axle shaft must be moved outwards before measuring.
4. Push on the inner end of the inner axle shaft and move the shaft outboard as far as it will go.
5. Install the J 34673 (1) and the J 34672 (2) onto the inner shaft housing as shown.
6. Using the J 34672, measure the distance from the edge of the inner axle shaft to the surface of the J 34673. Ensure the base of the J 34672 is flat
against the inner axle shaft.
