Sierra 1500 4WD V8-6.0L (2007)
3. Install the axle shaft seal using the J 21128 (8.6 inch and 9.5 inch LD axles) or the J 29713 (9.5 inch axle).
4. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
5. Install the axle shaft.
6. Install the rear axle housing cover.
7. Install the tire and wheel assembly.
8. Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) Rear Axle Lubricant Replacement (9.5 LD Axle) Rear Axle
Lubricant Replacement (9.5 Inch HD and 10.5 Inch Axles).
9. Lower the vehicle.
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum)
Rear Axle Shaft Seal and/or Bearing Replacement (w/Rear Drum)
Tools Required
*
J 8092 Universal Driver Handle-3/4 in - 10
*
J 21128 Axle Pinion Oil Seal Installer
*
J 23690 Axle Shaft Bearing Installer
*
J 2619-01 Slide Hammer
*
J 44685 Rear Axle Seal and Bearing Remover
Removal Procedure
1. Remove the axle shaft.
2. Remove the axle shaft seal and the bearing from the axle housing using the J 44685 (1) and the J 2619-01 (2).
Installation Procedure
