Sierra 1500 4WD V8-6.0L (2007)
8. Install the boot (1) and the boot clamp (2) on the tripot housing (3).
9. For the 1500 models, assemble the bolts and the support plate to the base of the J 36652-98 and secure the base in a vise.
10. For the 2500, 3500 models, assemble the bolts and the support plate to the base of the J 36652-1 and secure the base in a vise.
11. Position the tripot end of the wheel drive shaft assembly into the base of the J 36652-98 for the 1500 models or J 36652-1 for the 2500, 3500
models.
12. Install the top half of the J 36652-98 for the 1500 models or J 36652-1 for the 2500, 3500 models.
13. Align the boot clamp (2) and the clamp.
Important: Hand tighten the bolts until the bolts are snug.
14. Insert the bolts.
15. Align the tripot boot, tripot housing, and the boot clamp.
Important: Alternate between the bolts until both sides of the top half of the tool touch the bottom half.
16. Tighten each bolt 180 degrees at a time.
17. Loosen the bolts and remove the halfshaft assembly from the tool.
