Sierra 1500 4WD V8-6.0L (2007)
6. Remove the spacer from the rear of the crankshaft, if applicable.
Installation Procedure
Important:
*
The flywheel does not use a locating pin for alignment and will not initially seat against the crankshaft flange or spacer, if applicable, but
will be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a three stage tightening process.
*
Certain applications (6.0L) require a spacer and longer bolts for proper flywheel position.
1. Install the spacer, if applicable, onto the rear of the crankshaft.
Important: Longer flywheel bolts must be used on applications using a flywheel spacer.
2. Install the flywheel and bolts to the crankshaft.
3. Apply threadlock to the threads of the flywheel bolts. Refer to Sealers, Adhesives, and Lubricants for the correct part number.
Notice: Refer to Fastener Notice.
4. Tighten the flywheel bolts.
1. Tighten the bolts (1-6) a first pass in sequence to 20 N.m (15 lb ft).
