Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
Notice: Refer to Fastener Notice.
1. Install the power steering gear inlet hose (2) to the vehicle.
2. Connect the power steering gear inlet hose (4) to the steering gear.
Tighten the fitting to 32 N.m (24 lb ft).
3. Install the power steering gear inlet hose clip bolt (3).
Tighten the bolt to 12 N.m (106 lb in).
4. Connect the power steering gear inlet hose (1) to the power brake booster.
Tighten the fitting to 32 N.m (24 lb ft).
5. Clean any excess power steering fluid from the vehicle and remove the drain pans.
6. Fill and bleed the power steering system.