Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
Intake Air Temperature Sensor: Service and Repair
Intake Air Temperature (IAT) Sensor 2 Replacement
Intake Air Temperature (IAT) Sensor 2 Replacement
Removal Procedure
1. Remove the air intake pipe.
2. Disconnect the engine wiring harness electrical connector (1) from the intake air temperature (IAT) sensor pigtail.
3. Remove the IAT sensor (2) from the center intake manifold.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the IAT sensor (2) to the center intake manifold.
