Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
Removal Procedure - EGR Valve Motor
Disconnect the negative battery cable.
Remove the air cleaner outlet duct, if necessary. Refer to Air Cleaner Outlet Duct Replacement in SI.
Remove the EGR valve motor harness connector.
Remove the four mounting screws from the EGR valve motor to the EGR valve. Discard the old mounting screws.
Remove the EGR motor and spacer (if equipped) from the engine. Save the spacer.
The EGR valve motor is packaged with new mounting screws.
Install the spacer (if equipped), the EGR valve motor P/N 98057041 and the new mounting screws to the EGR valve.
Tighten
Tighten the four new mounting screws to 2 N.m (18 lb in).
Install the EGR valve motor harness connector.
Install the air cleaner outlet duct, if removed. Refer to Air Cleaner Outlet Duct Replacement in SI.
Connect the negative battery cable.
Cycle the ignition key to the run position with the engine not running to relearn the new EGR valve motor pintle position.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table.
