Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
3. Position the EGR valve cooler rear bracket to the cylinder head and install the bolts.
Tighten the bolts to 25 N.m (18 lb ft).
4. Connect the engine wiring harness electrical connector (1) to the fuel rail fuel pressure sensor wiring harness extension electrical connector.
5. Install the fuel rail fuel pressure sensor wiring harness extension clip (3) to the wiring harness bracket.
6. Install the right exhaust pipe.
7. Install the EGR valve cooler.
8. Prime the fuel system. Refer to Fuel System Priming.
9. Start the engine. If the engine stalls, repeat the above step.
10. Once the engine starts, inspect for fuel leaks.
