Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
6. Working through the wheelhouse, loosen the charge air cooler inlet pipe connector clamp (1) at the charge air cooler.
Important: Do not use a screwdriver or other tool to pry the connector loose. The connector can be torn or damaged. Loosen the
connector by twisting.
7. Remove the charge air cooler inlet pipe connector (2) from the charge air cooler.
8. Lower the vehicle.
9. Remove the charge air cooler inlet pipe from the vehicle.
Installation Procedure
1. Install the charge air cooler inlet pipe to the vehicle.
2. Remove the turbocharger opening cover.
Important: Do not over tighten the charge air cooler connector clamp. If the clamp is overtightened, the connector may become distorted
allowing separation of the connector from the pipe. Make sure the charge air cooler pipe is properly orientated.
