Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor Replacement
Camshaft Position Sensor Replacement
Removal Procedure
1. Remove the cooling fan pulley.
2. Remove the camshaft position (CMP) sensor bolt.
3. Remove the CMP sensor.
Installation Procedure
1. Lubricate the CMP sensor O-ring with clean engine oil.
2. Install the CMP sensor.
Notice: Refer to Fastener Notice.
3. Install the CMP sensor bolt.
Tighten the bolt to 10 N.m (89 lb in).
4. Install the cooling fan pulley.
