Sierra 2500 2WD V8-6.6L DSL Turbo (2007)
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the turbocharger vane position sensor to the turbocharger.
Tighten the sensor to 28 N.m (21 lb ft).
2. Install the turbocharger vane position sensor electrical connector clips to the wiring harness bracket.
3. Connect the engine wiring harness electrical connector (1) to the turbocharger vane position sensor electrical connector (1).
4. Install the thermal reflective shield/tape, if required.
Thermal Reflective Shield/Tape Installation
Important: