Sierra 2500 2WD V8-6.6L DSL Turbo VIN 2 (2004)
4. Remove the tape from the turbocharger openings.
5. Important: Lubricate the end of the duct prior to installation.
Install the charged air cooler inlet duct connector (4) to the turbocharger.
6. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten the clamp to 6 Nm (53 inch lbs.).
7. Fill the cooling system.
8. Install the intake manifold cover
Engine - Outlet Pipe
Turbocharger Coolant Hoses/Pipes Replacement (6.6L (LLY) Engine - Outlet Pipe)
Removal Procedure
1. Remove the intake manifold cover.
2. Drain the cooling system.
