Sierra 2500 4WD V8-6.0L (2008)
1. Install a NEW CMP actuator magnet gasket (753) onto the CMP actuator magnet.
2. Install the CMP actuator magnet (752) to the front cover.
Notice: Refer to Fastener Notice .
3. Install the CMP actuator magnet bolts (751).
Tighten the bolts to 12 N.m (106 lb in).
4. Connect the engine harness electrical connector to the CMP actuator magnet.
5. Install the water pump. Refer to Water Pump Replacement (LU3) (See: Water Pump/Service and Repair)Water Pump Replacement (LY6, L76
and L92) (See: Water Pump/Service and Repair)Water Pump Replacement (LH6, LY2, LY5, and LMG) (See: Water Pump/Service and Repair
)Water Pump Replacement (LMM) (See: Water Pump/Service and Repair) .
