Sierra 2500 4WD V8-6.0L (2008)
2. Install the valve lifter oil manifold (1) to the engine.
Notice: Refer to Fastener Notice .
3. Install the valve lifter oil manifold bolts (2).
Tighten the bolts to 25 N.m (18 lb ft).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
5. Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) (See: Intake Manifold/Service and Repair)Intake Manifold
Replacement (L92 - Second Design) (See: Intake Manifold/Service and Repair)Intake Manifold Replacement (LY2 and LY6) (See: Intake
Manifold/Service and Repair)Intake Manifold Replacement (LH6, LMG, LY5 and L76) (See: Intake Manifold/Service and Repair) .
