Sierra 2500 4WD V8-6.0L (2008)
Notice: Refer to Fastener Notice .
2. Install the engine mount to engine bolts (1).
Tighten the bolts to 50 N.m (37 lb ft).
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block.
5. Install the left side exhaust manifold heatshield. Refer to Exhaust Manifold Heat Shield Replacement - Left Side (4.3L) (See: Exhaust
System/Heat Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left Side)Exhaust Manifold Heat Shield Replacement - Left
Side (4.8L, 5.3L, 6.0L, and 6.2L) (See: Exhaust System/Heat Shield/Service and Repair/Exhaust Manifold Heat Shield Replacement - Left Side) .
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
