Sierra 2500 4WD V8-6.0L (2008)
Tighten the bolt to 20 N.m (15 lb ft).
5. Remove the caps from the fuel and EVAP lines.
6. Connect the fuel tank EVAP line quick connect fitting to the chassis line.
7. Connect the fuel tank fuel feed line quick connect fitting to the chassis line.
8. Unsecure and position the EVAP canister vent solenoid clip (1) to the chassis EVAP line.
9. Install the EVAP canister vent solenoid pipe clip (2) from the chassis EVAP line.
10. If equipped with 4WD, install the fuel hose/pipe clip to the bracket on the transfer case.
11. Install the fuel line clip to the bracket on the automatic transmission.
12. Install the fuel pipe bracket nut to the bellhousing stud.
Tighten the nut to 25 N.m (18 lb ft).
13. Position and install the BPMV. Refer to Brake Pressure Modulator Valve Replacement (JD9, JF3, JF7) Brake Pressure Modulator Valve
