Sierra 2500 4WD V8-6.0L (2008)
1. Position and install the fuel/EVAP line assembly to the vehicle.
2. Install the fuel/EVAP line bracket locator tab to the frame.
3. Install the fuel/EVAP line clips to the frame and crossmember.
Notice: Refer to Fastener Notice.
4. Install the fuel/EVAP line clip nuts (2).
Tighten the bolt to 20 N.m (15 lb ft).
5. Remove the caps from the fuel and EVAP lines.
6. Connect the fuel tank EVAP line quick connect fitting to the chassis line.
7. Connect the fuel tank fuel feed line quick connect fitting to the chassis line.
8. Unsecure and position the EVAP canister vent solenoid clip (1) to the chassis EVAP line.
9. Install the EVAP canister vent solenoid pipe clip (2) from the chassis EVAP line.