Sierra 2500 4WD V8-6.0L (2008)
necessary.
25. Install the propeller shaft (3) to the pinion yoke (4).
Align the reference marks made during removal.
26. Install the propeller shaft yoke retaining clamps and the bolts.
Tighten the propeller shaft yoke retaining clamp bolts to 25 N.m (18 lb ft).
27. Install the axle shafts. Refer to Rear Axle Shaft and/or Gasket Replacement (See: Drive Axles, Bearings and Joints/Seals and Gaskets/Service and
Repair/Rear Axle Shaft and/or Gasket Replacement) .
28. Fill the axle with axle lubricant. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) (See: Fluid - Differential/Service and Repair/Removal
and Replacement/Rear Drive Axle/Rear Axle Lubricant Replacement (8.6 Inch Axle))Rear Axle Lubricant Replacement (9.5 Inch LD Axle) (See:
Fluid - Differential/Service and Repair/Removal and Replacement/Rear Drive Axle/Rear Axle Lubricant Replacement (9.5 Inch LD Axle))Rear
Axle Lubricant Replacement (10.5 Inch Axle) (See: Fluid - Differential/Service and Repair/Removal and Replacement/Rear Drive Axle/Rear
Axle Lubricant Replacement (10.5 Inch Axle)) .
29. Lower the vehicle.