Sierra 2500 4WD V8-6.0L (2008)
1. Install the control lever.
2. If alignment of the control lever is necessary, or if the shift lever assembly was replaced perform the following:
1. The nut must be seated at the bottom of the thread runout on the shift lever.
2. Seat the control lever against the shift lever assembly adjustment nut.
3. Back the control lever off the nut in order to align the index mark on the control lever perpendicular to the edge of the control lever boot
retainer.
4. Ensure that the index mark is located on the passenger side and that the shift pattern is aligned parallel to the vehicle centerline or rotated no
more than 6 degrees clockwise.
Notice: Refer to Fastener Notice .
5. Hold the control lever and tighten the shift lever assembly nut against the control lever.
Tighten the nut to 37 N.m (27 lb in).
6. Install the control lever boot to the control lever.
Transmission Control Replacement
Transmission Control Replacement
Removal Procedure
Important:
*
Ensure that the control lever is positioned into the mechanical third or fourth gear prior to removal of the shift lever from the
transmission. The transmission must remain in this state when the shift lever is removed.
*
Do not disassemble the transmission shift lever. Internal parts for this shift lever are not available. Opening the shift lever voids the
warranty.
*
When removing the shift lever from the transmission, use the exposed bolts on the base of the lever.
1. Remove the control lever and boot. Refer to Transmission Control Lever Boot Replacement (See: Tremec 5-Speed (M96) - Manual
Transmission/Transmission Control Lever Boot Replacement) .
2. Remove the boot.
3. Remove the shift lever bolts.
4. Remove the shift lever and seal.
5. Remove the shift lever insulator.
