gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Seals and Gaskets, Transfer Case|Service and Repair > < Drivetrain - Transfer Case Rear Output Shaft Seal Leak|Page 16564
Page 2
background image

TECHNICAL

Bulletin No.: 09-04-21-002A

Date: July 09, 2009

Subject: Transfer Case Rear Output Shaft Oil Seal Leak (Replace Rear Output Shaft Seal)

Models:

2007-2009 Chevrolet Silverado 2500/3500 Series
2008-2009 Chevrolet Suburban 2500 Series
2007-2009 GMC Sierra 2500/3500 Series
2008-2009 GMC Yukon XL 2500 Series
Equipped with Magna Transfer Case RPO Codes NQF, NQG, NQH

Attention:

This bulletin ONLY applies to 2500/3500 Series (3/4 and 1 Ton) vehicles.

Supercede:
This bulletin is being revised to clarify which models are involved. Please discard Corporate Bulletin Number 09-04-21-002 (Section 04 -
Driveline/Axle).

Condition

Some customers may comment on a fluid leak. Upon investigation, the technician may find a fluid leak that appears to be coming from the transfer case
rear output shaft oil seal.

Correction

Verify that the leak is coming from the transfer case rear output shaft oil seal. If the leak is coming from the rear output oil seal, replace the seal with GM
P/N 24226707. This new seal was released to address this concern and has better wear and temperature resistance. Refer to SI for proper replacement
procedures.

Parts Information

Warranty Information

For vehicles repaired under warranty, use the table above.

Disclaimer

Seals and Gaskets, Transfer Case|Service and Repair > < Drivetrain - Transfer Case Rear Output Shaft Seal Leak|Page 16564