Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
3.
Remove and discard the two brake caliper bracket bolts (5). Do not remove both bolts at the same time. Remove one bolt and proceed to Steps
4-5. Remove the second bolt and proceed to Step 4-5.
4.
Apply Threadlocker to the new brake caliper bracket bolt (5).
5.
Install the new brake caliper bracket bolt (5).
Tighten
Tighten the new brake caliper bracket bolt to 200 Nm (148 lb ft).
6.
Install the right rear passenger side tire and wheel assembly. Refer to Tire and Wheel Removal in SI.
7.
Lower the vehicle.
Claim Information
For vehicles repaired under this service update, use the table.
Disclaimer