Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
4. Position the glow plug control module onto the bracket and install the bolts.
Tighten the bolts to 10 N.m (89 lb in).
5. Connect the engine wiring harness electrical connector (2) to the glow plug control module.
6. Connect the positive battery cable (1) to the glow plug control module.
7. Connect the negative battery cable.
8. If a NEW glow plug control module was installed, program the module. Refer to Refer to Programming and Relearning.. See: Testing and
Inspection/Programming and Relearning
