Sierra 2500 4WD V8-6.6L DSL Turbo (2007)
Actuator: Service and Repair
Front Drive Axle Actuator Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the engine shield, if equipped.
3. Disconnect the electrical connector from the actuator.
4. Remove the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.5 inch axle (4) by turning the actuator counterclockwise.
Installation Procedure
1. Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4). Use the correct sealant. Refer to Sealers,
Adhesives, and Lubricants.